Theyalso sent the wrong a different story. 2000 Jetta 2.0L. I need torque specs for: -The four 6mm allen bolts for the crankshat serpantine belt pulley. -Timing belt tensioner nut. -The water pump bolts. -Serpentine belt tensioner bolts. -All of the passenger side motor mount bolts (to engine and to.
Thefirst table contains the most-used torque settings. The tables after it contain all torque spec values I could find. Most-used torque settings for Audi A3 2. Part Description Torque (Nm) 1.9L TDI Engine; Alternator: Alternator B+ terminal: 15: 11: to 06.2008: 1.8L TFSI Engine; Belt tensioner/Timing chains: Tensioner for poly V-belt
Yes M16 - Engine mount BRACKET to block - 33 ft lbs, reusable. M16 - Engine mount to body - 30 ft lb + 90º, one time use. M18 - Engine mount to engine mount BACKET - 74 ft lbs, one time use*. * I'm not sure whether they changed the "replace" recommendation when they updated the torque spec.
. #1. Since first working on the PD motors, we found the setting of the torsion value a bit of a mystery. The torsion value is located in VCDS/Engine Module/ block 4/ torsion value. We tended to figure that 0.0 was a good figure and originally let it go at that. However, early on, we had a Passat Wagon that lost 4 mpg when we set
Maximumtorque 440 Nm (324 lb-ft) @ 1900 rev/min Engine oil pressure: At idle 0.7 bar (70 kPa) (10 lb/in²) At 3500 rev/min 1.9 bar (190kPa) (27.5 lb/ft²) Description Nm lb-ft Accessory drive belt idler retaining bolt 47 35 Accessory drive belt tensioner M8 retaining bolts 47 35
Itreduces the load on the crankshaft bearings and the noise from vibrations. The 2.0 TDI CR uses its pistons with a more volume combustion chamber, because of this the engine
YBK5Ep. 329 170 206 242 254 461 282 280 337
2.0 tdi timing belt torque specs
